Use this clear overlaminate to provide an extra layer of protection and/or enhance the gloss of an electrostatically imaged graphic – both indoors and out. It also can be used to laminate selected Piezo Ink Jet graphics.

When used with compatible products, produced by one of 3M’s Scotchprint® Graphics Authorized Manufacturers and applied according to written instructions, this film can be used to produce a Scotchprint® Graphic.

• Overlaminate 8908 (ES) produces a luster finish and can be used with most squeeze roll laminators; no heat is required.

• This overlaminate features 3M’s patented e-film technology, offering the following benefits:
• minimal shrinkage, resulting in no edge lifting

• flexibility at a wider range of temperatures
• good surface conformance
• excellent cutting capabilities

Overlaminate 8908 (ES):

• is a 2 mil (0.05 mm) transparent, vinyl film; 3 mil (0.08 mm) with the adhesive
• has a clear, permanent pressure-sensitive adhesive
• has a 78# paper liner

This film can be used on flat surfaces with or without rivets, simple curved surfaces and corrugated surfaces. It has a lamination temperature range of 50º to 90ºF (10º to 32ºC).

Overlaminate 8908 (ES) can be used to laminate:

• Selected 3M^TM Controltac^TM Plus Electrostatic Graphic Films
• Selected 3M^TM Scotchcal^TM Electrostatic Graphic Films
• Selected 3M^TM Piezo Ink Jet Graphic Films
• 3M^TM Banner Material 8450

This product is covered by the 3M^TM MCS^TM Warranty – the most comprehensive warranty in the industry.

Overlaminate 8908 (ES) is available in 35.5", 49" and 53.5" wide by 100-yard long rolls.

This overlaminate has a shelf life of two years. It should be stored in a clean, dry area, out of direct sunlight, and at a temperature less than 100ºF (38ºC).

For more specific product information, please refer to Product Bulletin 8908.